LifeFitness Club Series Assembly Instructions Manual page 7

Step 10
Locate the POLAR RECEIVER (#16). Slide the FOAM ISO-
LATOR #15) over the POLAR RECEIVER. Remove
the POLAR RECEIVER JACK (G) from the tape
and plug the POLAR RECEIVER into the POLAR
RECEIVER JACK.
Step 11
Locate the front and back MONOCOLUMN
COVERS (#5 & #6). With the wire positioned on top,
carefully insert the POLAR RECEIVER (#16) between
the vertical ribs located inside the BACK MONOCOLUMN
COVER(#6).
Place the BACK MONOCOLUMN COVER (#6) over the PIVOT
SHAFT (H) at the top of the MONOCOLUMN (F).
NOTE: THE POLAR RECEIVER WIRE MUST BE POSITIONED ON TOP
WHEN INSERTED INTO THE REAR MONOCOLUMN COVER(#6).
REMARQUE :LE FILDU RÉCEPTEUR POLAR DOIT ÊTRE PLACÉ SUR LE DESSUS
LORS DE L'INSERTION DANS LE CACHE ARRIÈRE DE LACOLONNE CENTRALE (Nº 6).
Step 12
Place the FRONT MONOCOLUMN COVER(#5) on the opposite side of the BACK MONOCOLUMN COVER (#6) to
cover the PIVOT SHAFT(G) and CONSOLE SUPPORT ASSEMBLY MOUNTING SCREWS. Interlock the
tabs and use two PHILLIPS PAN HEAD SCREWS (#3) to secure the bottoms of MONOCOLUMN COVERS together.
Tighten the screws securely.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD SCREWS (#3).
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLINDRIQUE
(Nº 3).
Step 13
Locate one FRONT ROCKER COVER (#13) and one BACK ROCKER COVER (#14). Position the FRONT
ROCKER COVER over the user side of the left end of the PIVOT SHAFT(H) (as shown) making sure that it
interlocks with the MONOCOLUMN COVERS (#5 & #6). Place the BACK ROCKER COVER over the opposite
side of the left end of the PIVOT SHAFT in the same manner. Secure the covers using three PHILLIPS PAN
HEAD SCREWS (#3). Repeat the procedure reversing front and back for the user right end of the pivot shaft.
CAUTION: DO NOT OVER-TIGHTEN THE PHILLIPS PAN HEAD SCREWS (#3).
MISE EN GARDE : NE SERREZ PAS EXCESSIVEMENT LES VIS CRUCIFORMES À TÊTE CYLINDRIQUE
(Nº 3).
top