Error Indications And Fault Occurrence Causes; Error Message List - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW

3.3 Error Indications and Fault Occurrence Causes

3.3.1 Error Message List

You can handle most of the troubles with messages/instructions shown on the LCD panel.
Error Name
Fatal error
(System)
A printer error has occurred.
Turn off the printer and turn it on again. See your documentation.
Fatal error
(printer mechanism)
Fatal error
A scanner error has occurred. Please see your documentation.
(Scanner)
Maintenance request (waste ink over The printer's ink pads are at the end of their service life.
flow) Please contact Epson Support.
Paper is jammed in the printer. Turn off the printer, open the scanner unit, and
Paper jam error remove the paper.
See your documentation.
Ink end error You need to replace the following ink cartridge(s).
No ink cartridge error The following ink cartridges have not been installed. Install them.
Incorrect ink cartridge Cannot recognize the following ink cartridge(s). Install them correctly.
The ink cartridge cover is open. Open the scanner unit and close the ink
Ink cartridge cover open error
cartridge cover. Press OK to continue.
Paper out.
Paper out error
Load paper and press the Start button.
Head cleaning
Replace the following ink cartridge(s) before cleaning the print head.
(Ink low error)
DSC Direct error Cannot recognize the device.
TROUBLESHOOTING
Table 3-3. Error Indications and Fault Occurrence Causes
LCD Message
Error Indications and Fault Occurrence Causes
Error Cause
RAM trouble occurs.
System trouble occurs.
Mechanical trouble occurs.
Scanner error occurs.
The waste ink counter exceeds to capacity.
Paper stays in the paper path after paper ejection.
Ink is out in some I/C.
No I/C is set.
Incorrect I/C is set.
Ink replacement was attempted with the Ink Cartridge
Cover open.
Failure to load paper to print.
Head cleaning was attempted in the Ink low status.
A device not supported is connected to the port for the
connection of external memory devices.
The DSC demands the current larger than mechanical
limit.
Revision A
Reference
Table 3-4. (p50)
Table 3-5. (p56)
Table 3-6. (p56)
Table 3-7. (p59)
Table 3-8. (p60)
Table 3-9. (p60)
Table 3-10. (p62)
Table 3-11. (p62)
48
Confidential