Disassembling The Printer Mechanism; Printhead - Epson WorkForce 600 Service Manual

EPSON WorkForce 600/EPSON Stylus OFFICE TX600FW/BX600FW/EPSON Stylus SX600FW/ME OFFICE 700FW
Tighten the screws in the order given in
Secure the Power Supply Unit Cable with the hook of the Base
Frame as shown in the figure below.
Put the ferrite core of the Power Supply Unit cable into the
hole of the Base Frame.
Ferrite core
Base Frame
Figure 4-41. Routing the Power Supply Unit Cable
DISASSEMBLY/ASSEMBLY
Figure. 4-39.
Power Supply Unit Cable
Hook

Disassembling the Printer Mechanism

4.5 Disassembling the Printer Mechanism

4.5.1 Printhead

Parts/Components need to be removed in advance
Scanner Unit/ADF Unit/Upper Housing /Hinge/Middle Cover
Removal procedure
1. Rotate the Spur Gear 51.5 to unlock the carriage, and move the CR Unit to the
center.
Spur Gear 51.5
Figure 4-42. Unlocking the Carriage and Moving the CR Unit
2. Open the Cartridge Cover and remove all the ink cartridges from the CR Unit.
The Cartridge Cover Hinge must be broken to be removed since the
C H E C K
hinge is permanently-set. When replacing the Printhead, make sure
P O I N T
to replace the Cartridge Cover Hinge with a new one.
Figure 4-43. Cartridge Cover Hinge
Revision A
CR Unit
Carriage Lock
Cartridge Cover Hinge
(top)
Cartridge Cover Hinge
(bottom)
Confidential
109