List Of Error Messages - Epson Stylus Photo R280 Service Manual

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
LED Indications
Error Name
Power
Communication error
-
Flashes at
Fatal error Off
high speed
Maintenance request Flashes
Off
error
alternately 2
Flashes at
CDR Guide error
-
high speed
Paper (CDR) jam
-
No paper
-
Multi-feed
-
CDR Tray error
-
Ink-out -
No ink cartridge
-
Wrong ink cartridge -
Cover open error
-
Note *: The "XXXX" represents the part number of the Ink Cartridge.
Chapter 3 Troubleshooting
Table 3-3. List of Error Messages
Ink Paper
Check all connections and make sure all devices are on. If the
- - power was turned off during printing, cancel the print job. If
the error does not clear, see your printer documentation.
Delete all print jobs and turn the printer off. Remove any
Flashes at
foreign objects from inside the printer. After a few minutes,
high speed
turn the printer back on.
Flashes Parts inside your printer are at the end of their service life. See
alternately 1 your printer documentation.
For sheets of paper, manually set the front tray in the lower
paper position. For a CD or DVD, manually set the front tray
Flash 2
in the upper CD/DVD position.
For sheets of paper, turn off the printer and then remove any
jammed paper by hand. For a CD or DVD, remove the CDR
- Flash
tray. Next, press the Paper button on the printer or click the
Eject button if it appears on this screen.
Reload the paper and manually set the front tray in the lower
paper position. Then press the Paper button on the printer or
- Light
click the Continue button if it appears on the screen.
To cancel all print jobs, click the Cancel button.
A page has not been printed, multiple pages have been fed
into the printer at once, or the wrong paper size has been fed
- Light
into the printer. Remove and reload the paper. Press the Paper
button if necessary.
- Light Reload the tray, then press the Paper button on the printer.
*
Light - Black: XXXX
*
Color: XXXX
Light -
...................
Epson recommends the genuine Epson cartridges listed
Light -
above. Click the How to button for ink cartridge replacement
instructions.
Close the printer cover.
Flash 2 Flash 2
3.2 Warning / Error Indications
STM3 Message
The printer cannot communicate with the PC
properly.
A mechanical error has occurred.
Waste ink pads need to be replaced.
• The CD-R guide (stacker) position does not
• The CD-R guide (stacker) is in the CD-R
A paper jam has occurred.
Failed to feed paper.
Multiple sheets of paper were fed at the same
time.
A CD-R tray was not detected.
The cartridge has run out of ink.
Ink cartridge(s) was not detected.
The Cover Open Sensor detects the Printer Cover
is open.
Error Cause
match with the print job.
printing position at power-ON.
Revision C
See the table for
Troubleshooting
Table 3-4 (p.33)
Table 3-5 (p.34)
-
Table 3-11 (p.43)
Table 3-8 (p.38)
Table 3-9 (p.40)
Table 3-8 (p.38)
Table 3-10 (p.42)
Table 3-7 (p.37)
Table 3-6 (p.36)
32
Confidential