Stacker Assy / Stacker Cover; Upper Housing - Epson Stylus Photo R280 Service Manual

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50

4.2.3 Stacker Assy / Stacker Cover

Parts/Components need to be removed in advance: Nothing
Removal procedure
1. Open the Stacker Cover.
2. Remove the Stacker Assy.
3. Release the Stacker Cover from the two shafts and remove the Stacker Cover.
Shaft
Stacker Assy
Figure 4-12. Removing the Stacker Assy / Stacker Cover
When installing the Stacker Assy, insert the guide pins of the
Stacker Assy into the lower grooves of the Guide Stacker Assy.
(The upper grooves are used when CDR is printed.)
Groove
Guide Pin
Figure 4-13. Installing the Stacker Assy
Chapter 4 Disassembly/Assembly
Shaft
Stacker Cover
Groove
Guide Pin
4.2.3 Stacker Assy / Stacker Cover (Removing Exterior Parts/Components)

4.2.4 Upper Housing

Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy
Removal procedure
1. Remove the four screws and remove the Upper Housing upward.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
[Rear Side]
4
1
Upper Housing
Groove
Figure 4-14. Removing the Upper Housing
Revision C
(No.4)
3
2
Groove
62
Confidential