Epson Stylus Photo R280 Service Manual page 39

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
Occurrence
Symptom
Timing
Paper is fed into the printer, but
ejected at once without any printing
operation.
Any time
Paper cannot go through between
the EJ Roller and the Star Wheel
Roller.
The leading edge of paper does not
reach the PF Roller.
Note : * Be careful not to let jammed paper rub against the nozzle surface of the Printhead, or it may damage the Printhead.
Chapter 3 Troubleshooting
Table 3-8. Troubleshooting for Paper Jam Error
Failed Part
3. Is the Torsion Spring 0.22 detached or attached
incorrectly?
PE Sensor
1. Is the Front Paper Guide Pad attached incorrectly? 1. Install the pad correctly.
Front Paper Guide
Pad
1. Is the Star Wheel Holder detached?
EJ Frame ASSY*
2. Is the EJ Frame Assy installed incorrectly?
3. Has the EJ Frame Assy become deformed
obstructing the paper path?
1. Is the Upper Paper Guide disengaged from the
Upper Paper Guide*
Main Frame?
3.3 Troubleshooting by Error Message
Check Point
3. Install the PE Sensor Lever and the
Torsion Spring 0.22 correctly.
PE Sensor Lever
Torsion Spring 0.22
1. Attach the Star Wheel Holder correctly.
Star Wheel Holder
2. Install the EJ Frame Assy correctly.
3. Replace the EJ Frame Assy.
1. Install the Upper Paper Guide correctly.
Revision C
Remedy Reference
4.4.17 "Front Paper
Guide Assy"(p.96)
4.4.9 "EJ Frame
Assy"(p.84)
4.4.15 "Upper Paper
Guide"(p.94)
Confidential
39