Epson Stylus Photo R280 Service Manual page 97

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
5. Remove the Front Paper Guide Assy, following the steps below.
(1) Lift part to disengage the left side of the Front Paper Guide Assy.
(2) Slide the assy leftward little by little to disengage the right side of the assy.
(3) Remove the Front Paper Guide Assy while releasing its shaft from the cutout
of the rib on the left side of the Main Frame.
Cutout
2
1
Removal Direction
Figure 4-110. Removing the Front Paper Guide Assy
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of Front Paper Guide Assy (p.123)
Chapter 4 Disassembly/Assembly
Front Paper Guide Assy
2
4.4.17 Front Paper Guide Assy (Disassembling the Printer Mechanism)
When installing the Front Paper Guide Assy, pull out the CDR
Tray Sensor cable as shown below.
CDR Tray Sensor Cable
Figure 4-111. Routing the CDR Tray Sensor Cable
Attach the long foot of the EJ Ground Spring as follows; (1)
put it through the gap under the portion contacts with the EJ
Roller, (2) let it contact with the Main Frame, (3) let it contact
with the PF Roller shaft, (4) put it through the hole on the
frame. When finished, make sure the spring properly contacts
with (1), (2), (3), and (4) points.
Contacts with PF Roller Shaft
Contacts with EJ Roller shaft
Contacts with Main Frame
1
2
1
Figure 4-112. Attaching the EJ Ground Spring
Be careful not to deform the EJ Ground Spring.
Revision C
[Left Front Bottom Side]
Pull out the cable
from here
Long foot of EJ Ground Spring
4
3
Hole
4
Gap
97
Confidential