Epson Stylus Photo R280 Service Manual page 74

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
When installing the Printer Mechanism, be careful of the
following:
Secure the Ink Tube Cover with the hook after inserting the
two ribs shown in
Wipe off any ink on the joint portion of the Waste Ink Tube
before reconnecting the tube. Ink on the joint portion makes
the tube likely to get disconnected.
As shown in Fig.4-43, insert the Waste Ink Tube over the tube
of the Waste Ink Tray until the top end of the Waste Ink Tube
contacts with the rib.
Waste Ink Tray
Figure 4-43. Cautions of inserting the Waste Ink Tube
Match the positioning holes with guide pins (two pairs) shown
in Fig.4-42 (p.73).
Tighten the screws in the order given in
Make sure the Waste Ink Tube or cables are not pinched
between the Printer Mechanism and the Lower Housing.
Chapter 4 Disassembly/Assembly
Fig.4-37 (p.72).
Top end of Waste Ink Tube
Tube of Waste Ink Tray
Tube of Waste Ink Tray
Waste Ink Tube
Rib
Fig.4-42 (p.73).
4.4.1 Removing the Printer Mechanism (Disassembling the Printer Mechanism)
When installing the Cover Case, match the two guide pins and
their two positioning holes
Route the CDR Guide Sensor Cable through the opening as
shown in Fig.4-44.
Cover Case
CDR Guide Sensor Cable
Figure 4-44. Installing the Cover Case
Whenever the Printer Mechanism is replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
• Refer to "5.1.2 Required Adjustments" (p.107)
Revision C
as shown in Fig.4-44.
Opening
74
Confidential