Epson Stylus Photo R280 Service Manual page 79

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of APG Unit (p.125)
Install the APG Unit following the procedure below.
1. Put a pin (thinner than Ø2mm) through the positioning
holes of the Main Frame and the right PG Cam on the CR
Shaft.
Positioning Hole
Pin (1)
Figure 4-57. Reinstalling the APG Unit (1)
2. Put the pin through the positioning holes of the Spur gear
28.8 and the APG Unit.
Figure 4-58. Reinstalling the APG Unit (2)
Chapter 4 Disassembly/Assembly
Right PG Cam
Front: Positioning Hole of Spur Gear 28.8
Back: Positioning Hole of APG Unit
Pin
APG Unit Spur Gear 28.8
4.4.4 APG Unit (Disassembling the Printer Mechanism)
3. Install the APG Unit to the Main Frame.
Pin
Figure 4-59. Reinstalling the APG Unit (3)
4. Check that the hooks ( ) are attached to the positioning
holes of the Main Frame, then screw the APG Unit.
Figure 4-60. Reinstalling the APG Unit (4)
Tighten the screws in the order given in
Revision C
APG Unit
Main Frame
Fig.4-55 (p.78).
79
Confidential