Table of Contents
Advertisement
Figure 54 Expert > Wireless > Guest Wireless > Guest Wireless Setup: Edit
The following table describes the labels in this screen.
Table 32 Expert > Wireless > Guest Wireless > Guest Wireless Setup: Edit
LABEL
DESCRIPTION
Active
Select this to activate the SSID profile.
Name (SSID)
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Intra-BSS Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients or
Blocking
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled,
wireless clients can access the wired network and communicate with each other. When
Intra-BSS is disabled, wireless clients can still access the wired network but cannot
communicate with each other.
WMM QoS
Check this to have the NBG6816 automatically give a service a priority level according to
the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Enable
Select this to turn on bandwidth management for the Guest Wi-Fi network.
Bandwidth
Management for
Guest WLAN
Maximum
Enter a number to specify maximum bandwidth the Guest Wi-Fi network can use.
Bandwidth
Security Mode
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings
as this device. After you select to use a security, additional options appears in this screen.
See
Section 11.3 on page 87
can select No Security to allow any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Apply
Click Apply to save your changes back to the NBG6816.
Cancel
Click Cancel to reload the previous configuration for this screen.
Chapter 11 Wireless LAN
for detailed information on different security modes. Or you
NBG6816 User's Guide
92
Advertisement
Table of Contents
