Wake On Lan - ZyXEL Communications WZF56R16 User Manual

Table 58 Expert > Maintenance > Remote Management > WAN Access
LABEL
Port
Access Status
Secured Client
IP Address
HTTPS
Port
Access Status
Secured Client
IP Address
Apply
Cancel

15.10.2 Wake On LAN

Wake On LAN (WoL) allows you to remotely turn on a device on the network, such as a computer,
storage device or media server. To use this feature the remote hardware (for example the network
adapter on a computer) must support Wake On LAN using the "Magic Packet" method.
You need to know the MAC address of the remote device. It may be on a label on the device.
Use this screen to remotely turn on a device on the network. Click the Expert > Maintenance >
Remote Management > Wake On LAN to open the following screen.
Figure 92 Expert > Maintenance > Remote Management > Wake On LAN
Chapter 15 Maintenance
DESCRIPTION
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG6816 using this
service.
Select All to allow all computes to access the NBG6816.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG6816.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG6816 using this
service.
Select All to allow all computes to access the NBG6816.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG6816.
Click Apply to save your changes back to the NBG6816.
Click Cancel to begin configuring this screen afresh.
NBG6816 User's Guide
142