Table of Contents
Advertisement
Click Expert > Security > IPv6 Firewall. The IPv6 Firewall screen appears as shown.
Figure 82 Expert > Security > IPv6 Firewall
The following table describes the labels in this screen.
Table 52 Expert > Security > IPv6 Firewall
LABEL
DESCRIPTION
Enable Firewall Rule
Enable Firewall Rule
Select this check box to activate the firewall rules that you define (see Add Firewall
Rule below).
Add Firewall Rule
Service Name
Enter a name that identifies or describes the firewall rule.
MAC Address
Enter the MAC address of the computer for which the firewall rule applies.
Dest IP Address
Enter the IPv6 address of the computer to which traffic for the application or service is
entering.
The NBG6816 applies the firewall rule to traffic destined for this computer.
Source IP Address
Enter the IPv6 address of the computer that initializes traffic for the application or
service.
The NBG6816 applies the firewall rule to traffic initiating from this computer.
Protocol
Select the protocol (TCP, UDP or ICMPv6) used to transport the packets for which you
want to apply the firewall rule.
Dest Port Range
Enter the port number/range of the destination that defines the traffic type, for
example TCP port 80 defines web traffic.
Source Port Range
Enter the port number/range of the source that defines the traffic type, for example
TCP port 80 defines web traffic.
Add Rule
Click Add Rule to save the firewall rule.
Firewall Rule
#
This is your firewall rule number. The ordering of your rules is important as rules are
applied in turn.
Chapter 14 Security
NBG6816 User's Guide
131
Advertisement
Table of Contents
