Configuring Clock Settings; Configuring Tray Settings; Resetting Service Defaults - Xerox WorkCentre 3615 System Administrator Manual

Initial Setup

Configuring Clock Settings

Use this menu to set the date and clock settings of the printer.
To configure the clock settings:
From the General Setup menu, click Clock Settings.
1.
2. Next to Date Format, Time Format, and Time Zone, select the setting for each from the
corresponding list.
3. Using the selected format, next to Set Date, enter the date.
4. Using the selected format, next to Set Time, enter the time.
Click Save Changes.
5.

Configuring Tray Settings

Use this menu to configure the paper trays for the paper size and type, set custom sizes, and turn the
display prompts on and off.
1. From the General Setup menu, click Tray Management.
2. Select a bypass tray option.
− To allow the print driver settings to specify the bypass tray mode, under Tray Settings, select
Bypass Tray Use Driver Settings For Print Job.
− To allow the control panel settings to specify the bypass tray mode, under Tray Settings, clear
Bypass Tray Use Driver Settings For Print Job.
3. Under Tray Settings, next to each tray selection, from the lists, select the paper size and paper type.
4. Under Tray Settings, for the paper width (X) and the paper length (Y), enter the custom paper sizes.
5. To have the display prompt you for the paper settings each time the paper tray is loaded, next to
Display Popup, select On.
6. Under Tray Priority, select the tray priority for paper usage.
Click Save Changes.
7.

Resetting Service Defaults

Use this menu to restart the printer or to reset the default settings for faxing, scanning, printer, and
network settings using CentreWare Internet Services. Restarting the printer can take up to five minutes,
during which time CentreWare Internet Services is not available.
1. At your computer, open a Web browser, in the address field, type the IP address of the printer, then
press Enter or Return.
Note: If you do not know the IP address of your printer, see
page 12.
2. Click Properties.
From the General Setup menu, click Resets.
3.
4. To reset a service default, next to the default service, click Power Off/On Printer.
5. To restart the printer without resetting any of the default settings, next to Power Off/On the Printer,
click Power Off/On Printer.
®
28 Xerox WorkCentre
System Administrator Guide
®
3615 Black and White Multifunction Printer
Finding the IP Address of Your Printer on