System Status Messages - Garmin G3X Touch Pilot's Manual

Annunciations & Alerts

SYSTEM STATUS MESSAGES

Message
[LRU name] hardware fault
Config module error
Config module missing
[LRU name] using backup RS-232
interface
[LRU name] temperature out of
spec
[LRU name] power supply fault
AHRS [number] not calibrated
AHRS [number] magnetometer
not calibrated
AHRS [number] not receiving
magnetometer data
AHRS [number] not receiving air
data
AHRS [number] not receiving GPS
data
292
Comments
The specified LRU has a hardware fault and
requires service.
The GDU has encountered a problem writing to/
from the config module The G3X Touch system
should be serviced.
The PFD1 config module is not connected.
The specified LRU was wired for both CAN and
RS-232 communication paths, and the device is
not communicating via CAN.
The specified LRU is either too hot or too cold.
Check installation and/or hardware for cause.
The specified LRU's internal power supply has
a problem or the input voltage is out of the
required specifications.
The specified AHRS is either not calibrated
or requires the post installation calibration
procedure. See G3X Touch installation manual
for calibration instructions.
The specified AHRS is either not calibrated or
requires the magnetometer post installation
calibration procedure. See G3X Touch
installation manual for calibration instructions.
The specified AHRS is not receiving
magnetometer data. Check installation and
configuration.
The specified AHRS is not receiving air data.
Check installation and configuration.
The specified AHRS is not receiving any or any
useful GPS information. Check installation and
configuration.
Garmin G3X Touch Pilot's Guide 190-01754-00 Rev. E