Garmin G3X Touch Pilot's Manual page 249

The pilot can interrupt ESP by pressing and holding the Autopilot Disconnect /
Control Wheel Steering (AP DISC / CWS) switch. Upon releasing the AP DISC / CWS
switch, ESP force will again be applied. ESP can also be overridden by overpowering
the servo's torque limit.
ESP is configured on the Electronic Stability Configuration page in Configuration
Mode. Refer to the Installation Manual for more information on configuring ESP.
ESP is enabled or disabled from the Automatic Flight Control System page or using
an externally wired ESP discrete switch.
Enabling/Disabling ESP using the G3X Touch Autopilot Interface:
1) From the PFD, touch the Autopilot Status Box. The Automatic Flight Control
System page is displayed.
2) Touch the ESP button on the Automatic Flight Control System page to
enable/disable ESP.
ESP can be configured to be automatically enabled on system power-up.
ESP Roll
Engagement
Indication
(ESP NOT
Engaged)
190-01754-00 Rev. E
Autopilot
Status Box
- Touch To
Display the G3X
Touch Autopilot
Interface
AFCS (ESP Enabled)
Garmin G3X Touch Pilot's Guide
Additional Features
G3X Touch Touch To
Autopilot Enable/
Interface Disable ESP
231