Trim And Flap Position Indicators (Optional); Turn Rate Indicator - Garmin G3X Touch Pilot's Manual

TRIM AND FLAP POSITION INDICATORS (OPTIONAL)

Elevator Trim, Aileron Trim, Rudder Trim, and Flap Position indicators can be configured
from the Engine/Airframe Input Configuration Page in Configuration Mode. Refer to the
G3X Touch Installation Manual for more information.
Flap Position

TURN RATE INDICATOR

The Turn Rate Indicator is located above the HSI. Tick marks to the left and right
of the displayed heading denote standard turn rates (3 deg/sec). A magenta Turn
Rate Trend Vector shows the current turn rate. The end of the trend vector gives the
heading predicted in 6 seconds, based on the present turn rate. A standard-rate turn
is shown on the indicator by the trend vector stopping at the standard turn rate tick
mark, corresponding to a predicted heading of 18˚ from the current heading. At rates
greater than 4 deg/sec, an arrowhead appears at the end of the magenta trend vector
and the prediction is no longer valid.
190-01754-00 Rev. E
Elevator Trim
Indicator
Indicator
Trim and Flap Position Indicators
Garmin G3X Touch Pilot's Guide
Flight Instruments
Aileron Trim
Indicator
Rudder Trim
Indicator
59