Setting The Flash Intensity For Manual Flash; Setting The Timing For Firing The Flash - Ricoh GR II Operating Manual

Setting the Flash Intensity for Manual Flash

The intensity of the internal flash can be set for when the flash mode is set
to [Manual Flash].
1
In the [Shooting] menu, select [Manual Flash Amount], and then
press the $ button.
2
1
Press the !" buttons to select a value.
You can select from the following fractions of the maximum flash intensity:
[Full], [1/1.4], [1/2], [1/2.8], [1/4], [1/5.6], [1/8], [1/11], [1/16], [1/22], [1/32], and
[1/64].
3
Press the MENU/OK button.
If the flash mode is set to [Manual Flash], the
set value appears on the shooting screen.
Note -----------------------------------------------------------------------------------------------------------
• In the [Key Custom Options] menu, [Flash Amount] can be registered to use to the ADJ. lever and the
Fn1, Fn2, and Effect buttons. (p.120, p.122)

Setting the Timing for Firing the Flash

You can set the timing at which the flash fires in [Flash Synchro Settings] of
the [Shooting] menu.
1st Curtain Fires the flash immediately after the exposure starts. (Default setting)
2nd Curtain Fires the flash just before the exposure ends. When shooting a subject in motion at a low shut-
ter speed, this makes it possible to naturally express the subject's motion as a trail of light.
82