Reset Wireless - Fuji Xerox DocuPrint CM115 w User Manual

• Reset Wireless

Purpose:
To reset the wireless connection settings. After executing this function, all information about the access point is
cleared.
Values:
No*
Yes
NOTE:
• This item is displayed only when Wi-Fi is set to On.
• TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
IP Mode Dual Stack*
IPv4
IPv4 Get IP Address
Wireless
IP Address
Subnet Mask
Gateway Address
NOTE:
• To set an IP address for IPv6 in Dual Stack mode, use the CentreWare Internet Services. For more information, refer to the
online Help on the CentreWare Internet Services.
• This item is displayed only when Wi-Fi is set to On.
• Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and then on.
Values:
LPD
Port 9100
*1
IPP
WSD
(Web Services on
Devices)
SNMP
StatusMessenger
168 Using the Operator Panel Menus and Keypad
Does not reset the wireless connection settings.
Resets the wireless connection settings.
DHCP/AutoIP* Automatically sets the IP address.
BOOTP
RARP
DHCP
Panel
Disables the Line Printer Daemon (LPD) port.
Disable
Enables the LPD port.
Enable*
Disables the Port 9100 port.
Disable
Enables the Port 9100 port.
Enable*
Disables the IPP port.
Disable
Enables the IPP port.
Enable*
Disables the Web Services on Devices (WSD) port.
Disable
Enables the Web Services on Devices (WSD) port.
Enable*
Disables the Simple Network Management Protocol (SNMP) UDP port.
Disable
Enables the SNMP UDP port.
Enable*
Disables the StatusMessenger feature.
Disable
Enables the StatusMessenger feature.
Enable*
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator panel.
Manually sets the IP address allocated to the printer.
Manually sets the subnet mask.
Manually sets the gateway address.