Using Installer To Set Up Connection And Install Software - Fuji Xerox DocuPrint CM115 w User Manual

 Using Installer to Set Up Connection and Install Software
NOTE:
• The following procedure sets up printer connection and then install the drivers and software. If you have already established
printer connection, see "Using Installer to Install Software" on page 53 to install the print driver and software immediately.
Launching the FX Printer Installation Screen
1
Insert the Software Pack CD-ROM into your computer to start the FX Printer Installation screen.
NOTE:
• For Windows 8, Windows 8.1, Windows Server
the upper right corner of the screen, and then select Run setup.exe.
• If the CD does not automatically launch, perform the following steps.
For Windows Server 2003, Windows Server 2008, and Windows Server 2008 R2, click Start  Run.
a
For Windows Vista
For Windows 8 and Windows Server 2012, right-click on the Start screen and click All apps  Run.
For Windows 8.1 and Windows Server 2012 R2, click
b Enter "D:\setup.exe" (in case your optical disk drive is D), and then click OK.
2
Click Setup Printer and Install Software.
3
If you agree to the terms of the License Agreement, choose I accept the terms of the license agreement,
and then click Next.
®
and Windows 7, click Start  All Programs  Accessories  Run.
®
2012, and Windows Server 2012 R2, click the message displayed on
on the Start screen  Run.
Printer Connection and Software Installation 51