Media Sensor Adjustment - Datamax I-Class Mark II Operator's Manual

2 . 3 M e d i a S e n
2 . 3 M e d i a S e
2 . 3 M e d i a S e
The Media Sensor needs to be positioned so that the printer can detect the presence of media and
the top-of-form (except for continuous stock, where the TOF is set through the front panel).
To adjust:
1. With media loaded, as described in Section 2.2, grasp the Slide Tab and move the Sensor
Eye Mark into position over media according to the table below.
Media Type
Die-cut
Notched
Reflective
Continuous
Chapter 2 - Printer Setup
s o r A d j u s t m e
n s o r A d j u s t m e
n s o r A d j u s t m
Media Sensor Selection and Adjustment
Sensor Eye Mark Position
Near the middle of the label
Centered over the notch
Centered over the black mark
Near the middle of the media
n t
n t
e n t
Sensing Required
Gap
Notch
Black Mark
Continuous

'Sensor Eye' Mark

Slide Tab
7