Fujitsu MAA3182SC Oem Manual page 220

Table 4.3
K* C* Q*
0 x x No sense data showing the error contents are held.
1 0C 01 Write error recovered with auto reallocation
10 00 ID CRC or ECC error
12 00 Sync byte not found for ID field
13 00 Sync byte not found for data field
15 xx Positioning error
17 xx Recovered error without ECC
18 xx Recovered data with ECC
These errors are errors detected during accessing
of the disk media, but they are recovered from
through the IDD's retry processing. However,
when "1" is specified in the DTE flag in the
MODE SELECT parameters, the command may
not necessarily be executed until it is completed.
1 37 00 Rounded parameter
The IDD's rounding processing was applied to
the MODE SELECT parameters specified by the
INIT.
2 04 00 Logical unit not ready
The logical unit specified by the command is in a
state where it cannot be accessed.
2 04 04 Logical unit not ready, format in progress
The logical unit specified by the command is
currently being formatted, so access is
impossible.
2 3E 00 Logical unit has not self-configured yet
The IDD's initial setup (reading of system
information) is not completed yet.
3 0C 02 Write error, auto reallocation failed
10 00 ID CRC or ECC error
11 xx Unrecovered read error
12 00 Sync byte not found for ID field
13 00 Sync byte not found for data field
14 01 No record found
These errors were detected during accessing of
the disk media, but they were errors which could
not be recovered from through the IDD's retry
processing.
* K: Sense Key
Q: Sub-sense code
** Except within the time required for the disk drive to reach the ready state (approx. 20 seconds)
after the power has been switched on, or after a start instruction has been executed by the
START/STOP UNIT command.
Sense data error classification (1 of 4)
Outline of Error
C: Sense Code
L: Logging Necessary? (shown in item 4.2.3)
C141-E039-01EN
Recovery Method
L*
(See Table 4.4.)
None 4
Need 8
None 9
** 10**
Need
None 11
None 5
Need 12
4 - 17