Fujitsu MAA3182SC Oem Manual page 213

Name
C* Q*
44 nn Internal target failure
45 80 Select/Reselect failure A response wait time-out from the INIT was detected in
47 nn SCSI parity error
48 00 INITIATOR
DETECTED ERROR
message received
49 00 Invalid message error
* C: Sense Code, Q: Sub-sense Code
4 - 10
Table 4.2 Sense and subsense codes (5 of 7)
An internal hardware error was detected in the IDD.
("nn" is a Fujitsu unique code (80 to FF))
• 80: Divide by zero was executed.
• 81: The MPU fetched an undefined command.
• 82: Parity error in the MPU or Buffer CRC error
(SCSI)
• 83: Buffer CRC error
• 84: DWFT CRC Error
• 85: LBA compare Error
• 86: DSP Abnormality
• 8A: An illegal command interrupt was detected in ESP
• 90: DSP resetting processing
• 91: FMT abort doesn't terminate within the specified
time.
• 92: The FMT command doesn't terminate within
the specified time.
• 94: An unexpected FMT interrupt occurred.
• 95: A FMT interrupt has no cause.
• 96: An error occurred in FMT which shouldn't happen.
• 98: An ESP error interrupt (gross error) was detected.
• 99: An unexpected ESP interrupt occurred.
• 9A: A DBM error interrupt (Busy) was detected.
• 9C: A DBM illegal interrupt was detected.
• 9E: An ENDEC parity error occurred.
• 9F: Data late error 1 occurred.
• A0: SPIN UP failed.
• A1: Initial SEEK (RTZ) failed.
• A2: INITIAL CALIBRATION failed.
• C0: FLASH-ROM erasing failed.
• C1: FLASH-ROM interrupt failed.
• D0: Data late error 2 occurred.
the RESELECTION phase.
A parity error was detected on the SCSI data bus.
• nn=00: The MESSAGE PARITY ERR message was
received.
• nn=90: COMMAND phase
• nn=98: MESSAGE OUT phase
• nn=A1: DATA OUT phase
• nn=C0: Other phase
The INITIATOR DETECTED ERROR message was
received from the INIT.
An unsupported or inappropriate message was received.
C141-E039-01EN
Explanation
Sense
key
4
B
B
B
B