Table of Contents
Advertisement
Recovery
method
10
1)
Issue the START instruction using the START/STOP UNIT command ("Immed" = 0).
2)
When the START/STOP UNIT command is terminated abnormally, perform
recovery method 1.
3)
When the START/STOP UNIT command is terminated normally, reissue the
original command (Retry).
11
1)
Wait for formatting (FORMAT UNIT command) to be completed.
2)
Reissue the original command (Retry).
12
1)
Set the "Number of Retries" value in the MODE SELECT parameters at the
"Default" value.
2)
Reissue the original command (Retry). (Note)
3)
If the error is not recovered from after the first retry, issue the REZERO UNIT command.
4)
Reissue the original command (Retry). (Note)
5)
If the error is not recovered from, perform one of the following.
• When the sense key is "HARDWARE ERROR [=4]," perform recovery method 1.
• When the sense key is "MEDIUM ERROR [=3]," implement alternate block
allocation processing (shown in Section 5.4).
Note When the original command is the REASSIGN BLOCKS command, it may be
necessary to reconfigure the defect list. For details, see the description of the
REASSIGN BLOCKS command (item 3.3.2).
13
1)
Generate the RESET condition or issue a BUS DEVICE RESET message for the
IDD that reported this error.
2)
After waiting 2 seconds or longer, reissue the original command (Retry), and if the
spindle motor's start mode is set on "Start by Command," issue the START
instruction by the START/STOP UNIT command ("Immed" = 0) before retrying.
3)
If the retry procedure (() does not terminate normally, perform recovery method 1.
14
1)
The MODE SELECT parameter is initialized at the "Save" value (if the "Save"
value does not exist, the "Default" value), so when it is necessary to set the inherent
parameter, issued the MODE SELECT command.
2)
Reissue the original command (Retry).
15
1)
When not linked from the SET LIMITS command, the cause of this error occurring
is that write operations at the setting terminal are prohibited, so cancel release that
and issue the original command. If it is impossible to release the write protected
switch at the system, perform recovery method 2.
2)
When linked from the SET LIMITS command, perform recovery method 2.
4 - 22
Table 4.4
Error recovery procedure (2 of 4)
Recovery processing procedure
C141-E039-01EN
Advertisement
Table of Contents
