Table of Contents
Advertisement
When access to logical data blocks outside the address range defined by this command by
linked commands which follow this command is specified, or when a prohibited type of access
operation is specified, that command is terminated with a CHECK CONDITION status
without being executed. (When there is a violation of the (DATA PROTECT [=7] / Write
protect [=27-00]: "WrInh" flag, or when there is a violation of the (DATA PROTECT [=7] /
No additional sense information [=00-00]: "RdInh" flag.) When this command is issued again
in a group of commands linked in a series, the 2nd SET LIMITS command is rejected and a
CHECK CONDITION status (DATA PROTECT [=7] / Command sequence error [=2C-00]) is
reported.
Notes:
1.
Commands which come under restrictions in read operations or write operations when
"1" is specified in the "RdInh" (read inhibit) or "WrInh" (write inhibit) flag are as
follows.
• READ
"RdInh"
• READ EXTENDED (*)
• READ LONG
• FORMAT UNIT
"WrInh"
• REASSIGN BLOCKS
• WRITE
• WRITE AND VERIFY (*)
*
When zero is specified in the processing block count that command is not
executed.
2.
Even if a write operation is prohibited by this command, "0" is indicated in the "WP
(write protect)" bit reported to the INIT in the MODE SENSE and MODE SENSE
EXTENDED commands.
3.
If "0" is specified in this command in the "WrInh" flag, execution of a FORMAT
UNIT command or REASSIGN BLOCKS command issued in linked form following
this command is permitted (the specification of the range where access is permitted is
not applied.)
• VERIFY (*)
• WRITE AND VERIFY (*)
• PRE-FETCH
• WRITE EXTENDED (*)
• WRITE LONG
C141-E039-01EN
• WRITE SAME
3 - 91
Advertisement
Table of Contents
