Table of Contents
Advertisement
(2)
Basic Disconnect Processing Procedure
Disconnect processing is executed basically by the following processing procedure.
1) If the IDD judges that it is possible for it to disconnect from the SCSI bus during execution
of a command, it sends a DISCONNECT message to the INIT and enters the BUS FREE
phase. At this time, if necessary, the IDD sends a message to activate a pointer in the INIT
which precedes sending of the DISCONNECT message.
concerning the pointer mechanism, refer to the SCSI pointer description in "SCSI Physical
Interface Specifications" and "Chapter 2 SCSI Messages."
2) After the IDD enters the BUS FREE phase, it is possible for the INIT to issue other
commands. Also, it is possible for an IDD which has performed disconnect processing to
receive input/output operation requests from each INIT (this is explained in the description
of the command queuing function in section 1.4).
3) The IDD executes the command which performs disconnect processing internally.
4) After that, the IDD executes reconnection processing at the point when it is necessary for
operation on the SCSI bus, reconnecting with the INIT (See item (6) concerning
reconnection processing).
(3)
Disconnect Processing Procedure after COMMAND Phase Execution
If commands are queued (see section 1.4), disconnect processing is performed immediately after the
COMMAND phase execution is completed. In this case, the IDD switches from the COMMAND
phase to the MESSAGE IN phase and sends the DISCONNECT message to the INIT.
(4)
Disconnect Processing Procedure After Data Transfer Execution
In commands which accompany a data transfer, disconnect processing may be performed
during DATA IN or DATA OUT phase execution or after transfer of the final data is
completed. In this case, caution is necessary when executing the following types of pointer
controls.
a. If disconnecting during a data transfer
In cases where data transfer has begun (DATA IN phase or DATA OUT phase) and it will
take time until transfer of subsequent data can be transferred (Example: When the data
buffer has been emptied by a READ command, or the data buffer has ceased to be empty
due to a WRITE command), disconnect processing is performed during data transfer. In
this case, the IDD sends the SAVE DATA POINTER message before sending the
DISCONNECT message. When the INIT receives the SAVE DATA POINTER message,
it must save the current value of the current data pointer and make it possible to transfer
the subsequent data at reconnection time.
b. If disconnecting after the final data transfer is completed
In the case of a disconnect after transfer of all the data necessary for execution of a
command has been completed normally, (Example: a WRITE command), the IDD sends a
DISCONNECT message after sending the SAVE DATA POINTER message.
After that, the IDD executes reconnection processing and enters the STATUS phase
immediately, reporting the status byte without requesting a data transfer.
C141-E039-01EN
Furthermore, for details
1 - 15
Advertisement
Table of Contents
