Fujitsu MAA3182SC Oem Manual page 29

Table 1.1
Flag End Status
0 Completed
Normally
Completed
1
Normally
×
Completed
Abnormally
Conditions Met
0
1 Conditions Met
×
Unable to Start
Receive
×
Reserved State
×
Forced
Termination
×
Queue Full
State
Only a single logical unit can operate a series of linked commands. When the IDD receives
the first command, the logical unit specified by the IDENTIFY message or the LUN field of
the CDB becomes the object of operation in a series of linked commands and the values
specified in the LUN field in the 2nd and subsequent CDBs are disregarded.
Note:
An INIT which uses the command link function must make the ATN signal in the
SELECTION phase TRUE and notify the TARG that it is capable of receiving messages
other than the COMMAND COMPLETE message. If "1" has been specified in the Link
bit of the CDB without the ATN being made TRUE by the INIT in the SELECTION
phase, the IDD terminates that command abnormally by sending a CHECK CONDITION
status (ILLEGAL REQUEST [=5] / Invalid field in CDB [=24-00]).
1 - 12
Responses to Link Specification Commands
Status
INTERMEDIATE
INTERMEDIATE
COMPLETE WITH FLAG
CHECK COMMAND COMPLETE
CONDITION
INTERMEDIATE
CONDITION MET
INTERMEDIATE
CONDITION MET COMPLETE WITH FLAG
BUSY COMMAND COMPLETE
RESERVATION COMMAND COMPLETE
CONFLICT
COMMAND COMMAND COMPLETE
TERMINATED
QUEUE FULL COMMAND COMPLETE
C141-E039-01EN
Message
LINKED COMMAND
COMPLETE
LINKED COMMAND
LINKED COMMAND
COMPLETE
LINKED COMMAND
Link Function
Effective
Effective
Not Effective
Effective
Effective
Not Effective
Not Effective
Not Effective
Not Effective