Table of Contents
Advertisement
d. Parameters Related to Device Type (Byte 20)
•
SSEC (soft sectoring)
When this bit is "1," it indicates that the data formatting method on the disk media is
"soft sectoring." However, since the IDD uses only the "hard sectoring" method
(refer to previously shown item b), this bit is disregarded.
impossible to change this parameter.
•
HSEC (hard sectoring)
When this bit is "1," it indicates that the data formatting method on the disk media is
"hard sectoring." However, since the IDD uses only the "hard sectoring" method, this
bit is disregarded. Furthermore, it is impossible to change this parameter.
•
RMB (removable medium)
When this bit is "1," it indicates that the memory media of the disk drive can be
replaced. When this bit is "0," it indicates that the memory media is fixed. However,
since the IDD has a fixed media, this bit is disregarded. Furthermore, it is impossible
to change this parameter.
•
SURF (surface addressing)
When this bit is "1," it indicates that after logical data block address allocation is
performed over all the sectors in order on the same memory surface (same head), it is
proceeding to the next memory surface (next head) after all the sectors have been
done. When this bit is "0," it indicates that after logical data block address allocation
is performed over all the sectors in order in the same cylinder (all heads), it is
proceeding to the next cylinder. In the IDD, only the latter type of addressing is
possible, so this bit is disregarded. It is also impossible to change this parameter.
3 - 40
C141-E039-01EN
Furthermore, it is
Advertisement
Table of Contents
