Setting Up The Base And Handset Charging Cradle; Connecting The Base - Gigaset C330 Owner's Manual

Setting up the base and handset charging cradle

The base and charging cradle are designed for use in enclosed dry rooms with a temperature
range of +5°C to +45°C.
¤
Install the base on a level, non-slip surface in a central location in your house or at.
Please note
Make sure you observe the range of the base for the handset connection.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside buildings.
The phone's feet do not usually leave any marks on surfaces. However, due to the multitude of
di erent varnishes and polishes used on today's furnishings, the occurrence of marks on the sur-
faces cannot be completely ruled out.
¤
The display is protected by a plastic lm. Please remove the protective lm!
Please note:
u
Never expose the telephone to the in uence of heat sources, direct sunlight or other electri-
cal devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.

Connecting the base

¤
Connect the receiver to the telephone
using the coiled cable supplied 1.
¤
Connect the telephone jack 2.
¤
Then connect the mains adapter 3.
¤
Insert the cable of the mains adapter into
the cable ducts 4.
Please note:
u
The mains adapter must always be con-
nected, as the phone will not operate
without a mains connection.
¤
Only use the mains adapter and phone
cord supplied. Pin connections on tele-
phone cables can vary (pin connections).
1 1
3 2
4
1
1