Setting Up The Base And Charging Cradle (If Included); Connecting The Base - Gigaset C300 Manual

Hide thumbs Also See for C300:

Table of Contents

Taking the first steps

Setting up the base and charging cradle (if included)

The base and charging cradle are designed for use in dry rooms in a temperature

range of +5°C to +45°C.

¤ Set up the base at a central point in the building on a level, non-slip surface or

mount the base or charger on the wall (¢ page 57).

Please note

Pay attention to the range of the base.

This is up to 300 m in unobstructed outdoor areas and up to 50 m inside build-

ings. The range is reduced when Eco Mode is activated (¢ page 38).

The phone's feet do not usually leave any marks on surfaces. However, due to the

multitude of different varnishes and polishes used on today's furnishings, the

occurrence of marks on the surfaces cannot be completely ruled out.

Please note:

u Never expose the telephone to the influence of heat sources, direct sunlight or

other electrical devices.

u Protect your Gigaset from moisture, dust, corrosive liquids and fumes.

¤ First, connect the telephone jack

and insert the cables into the cable

ducts.

¤ Then connect the power adapter 1.

Please note:

u The power adapter must always be

connected, as the phone will not

operate without a mains connection.

u Use only the power adapter and

phone cord supplied. Pin connec-

tions on telephone cables can vary

(pin connections, ¢ page 52).

Table of Contents