Placing The Handset In The Charging Cradle; Initial Charging And Discharging Of The Batteries; Setting The Date And Time - Gigaset C330 Owner's Manual

First steps

Placing the handset in the charging cradle

¤
Place the handset in the charging cradle with its display facing forward.
The supplied handset is registered with the base at the factory. You do not need to register it. If
you wish to use your handset with a di erent base or use further handsets with your base, you
will have to register them manually,
To charge the batteries, leave the handset in the charging cradle.
Please note
Only place the handset in the charging cradle that is intended for it.

Initial charging and discharging of the batteries

The correct charge level can only be displayed if the batteries are rst fully charged and dis-
charged.
Please note
u
After the rst battery charge and discharge you may replace your handset in the charg-
ing cradle after every call.
u
Always repeat the charging and discharging procedure if you remove the batteries from
the handset and re-insert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while, the charge capacity of the batteries will decrease for technical reasons.

Setting the date and time

Set the date and time so that the correct date and time can be assigned to incoming calls, and
so that the alarm can be used. You can set the date and time on the base or on any registered
handset.
Your telephone is now ready to use!
14
¤
Place the handset in the charging cradle for 12
hours.
¤
12 h
Then remove the handset
from the charging cradle
and do not replace it until
the batteries are fully dis-
charged.