Victory 2009 VISION Rider's Manual page 78

visionownersmanual.book Page 75 Wednesday, February 13, 2008 4:31 PM
INSTRUMENTS, FEATURES, & CONTROLS
Foot Control Adjustment
The brake pedal and shift pedal can be adjusted to
one of three positions. The controls are in the center
position as delivered from VICTORY.
To move the controls to the front or rear position, do
the following:
1. Use a 6mm Allen wrench to remove screw (1).
2. Slide the control forward or rearward in its track
until the threaded hole of the control aligns with
the front (2) or rear (3) screw hole in the footrest
support.
3. Reinstall the screw and torque to 96 lb-in. (11 Nm).
4. After adjusting the shift pedal, always readjust the shift linkage rod. Loosen both jam
nuts on the linkage and turn the shaft until the footpeg is about 90mm from the
floorboard (or to desired height). Tighten both jam nuts to 96 lb-in. (11 Nm).
2
3 1
75