Victory 2009 VISION Rider's Manual page 144

visionownersmanual.book Page 141 Wednesday, February 13, 2008 4:31 PM
Engine Oil & Filter Change (Cont.)
6. Clean the drain plug sealing surface on the crankcase. Remove the old seal washer
from the plug and install a new one.
7. Install the drain plug and tighten to the proper torque. DO NOT overtighten.
DRAIN PLUG TORQUE: 15 lb-ft. (20 Nm).
8. Clean the oil filter mounting threads and gasket sealing surface on the crankcase.
9. Make sure the new oil filter gasket is properly seated in the new oil filter, and apply a
thin film of clean engine oil to the gasket. Screw the new filter on until the gasket
contacts the filter mounting plate. Tighten the filter by hand an additional 3/4 turn.
10. Fill crankcase through the oil fill cap with approximately 4.5 quarts (4.25 liters) of oil.
Use only VICTORY brand Semi-Synthetic 20W-40 Motor Oil or equivalent oil for use
with wet clutches such as JASO MA rating.
CAUTION
Do not add chemical additives to the engine oil. Some automotive engine oils contain
additives that could damage or reduce the service life of the wet clutch in your motorcycle.
MAINTENANCE
141