Cornelius FCB - 2 Flavor Service Manual page 73

4. Place point of punch in slot on
shank nut right against valve
threads.
5. Strike end of punch with hammer.
6. After applying torque and perform-
ing staking (stainless steel valve
threads only) inspect the threads
and shank nut to ensure proper
thread engagement.
This is what the Delta shank nut clear-
ance should look like.
• Shank nut surface flush-to-0.023"
above Valve surface.
© 2003-2014, Cornelius Inc.
Pinnacle 2 and 4 Flavor Service Manual
- 69 -
Valve Shank Surface
Shank Nut Surface
Staking mark on threads
inside notch in Shank Nut.
Publication Number: 560007298SER