Compressor Replacement; Hot Gas Valve Rebuilding - Cornelius FCB - 2 Flavor Service Manual

C R
OMPRESSOR EPLACEMENT
1. Disconnect the power to the unit. Remove bottom rear cover (4 screws) and side panels (3 screws each).
2. Disconnect all wires to compressor. Remove 4 mounting
nuts.
3. Reclaim refrigerant. Remove insulation from around fittings. Unsweat suction line first. Cut the discharge
line on top of the compressor (be careful so the line can be spliced back together).
4. Remove the compressor and unsweat the discharge line. Reverse the procedure to install new compressor.
Replace the dryer. Evacuate and recharge the system.
H G V
OT AS ALVE
1. Disconnect the power to the unit. Remove side panels (3 screws each).
2. Reclaim refrigerant.
3. Rebuild the hot gas valve per the manufacturer's instructions.
4. Replace the dryer. Evacuate and recharge the system.
Hot gas
valve body
(inside)
© 2003-2014, Cornelius Inc.
:
R :
EBUILDING
FIGURE 73
Pinnacle 2 and 4 Flavor Service Manual
Nuts (4)
Compressor
- 55 -
FIGURE 72
Coil
screw
Publication Number: 560007298SER