Installing The Management Module Card In The 1U Power Unit - HP R12000 User Manual

the front of the HP DirectFlow UPS Management Module card. Multiple devices can monitor the UPS over the
network connection. The Management Module card is designed specifically for the power unit. It is not
intended for installation in other UPS devices.
For information about configuring access from the HP DirectFlow UPS Management Module card to the web
interface, see "Accessing the Management Module (on page 63)."
For more information about accessing, signing in, and configuring the web interface software, see the HP
DirectFlow UPS Management Module User Guide on the HP website
(http://www.hp.com/support/DFUPS_MM_UG_en).

Installing the Management Module card in the 1U power unit

IMPORTANT:
Module card.
To install the card in the UPS:
Remove the two screws securing the cover plate on the power unit, and then slide the plate out.
1.
It is not necessary to power down the UPS before installing the Management
Installation 58