Setting Related To Sorting Read - Omron V500-R521B2 User Manual

Setting related to sorting read

Bar code data to read are registered in this bar code reader beforehand and only the
registered bar codes are read using this function. When the read bar code does not
coincide with the registered data, buzzer sounds.
Up to 5 types of bar codes can be registered.
Menu sheet
Register one character each using
command. (*1)
Register with regular expression. (*1)
Sorting read operation starts.
*1 Execute the command "UE" to start sorting read operation.
When you enter the command "UE", reading system and communication specification are set as
follows. When sorting read function is used, do not change the setting basically.
To change a part of communication condition, etc, change it after you input command "UE" and
sorting read operation starts.
Item
Types of code, which is possible to read
Number of reading digits
Reading system Reading trigger
Reading operation
Reading valid time
Number of reading
coincidence
Communication speed
Data length
Parity
Communication Stop bit length
condition
Header
Footer
Transfer number of digits
RS/CS control
CS waiting time
Communication protocol
Process when reading is NG
Command
7Y
UE
Setting content
Reading permission for all types
No designated number of digits
Valid (Not full-time reading but trigger is used)
Single reading
Trigger + 2 sec.
Twice (Verification: once)
9600 bps
8-bit
None
1-bit
None
CR
Not transferred
None
Infinity
No protocol system
No process (Nothing is transferred)
Section 4
Setting Method
V500-R521B2/C2
User's Manual
83