Omron V500-R521B2 User Manual page 53

Section 4
Setting Method
Input command from the upper equipment
Upper equipment
1.
Transmit the command character strings of the function you want to set.
Menu Sheet/Command List p.56
During the bar code reader is processing command, it notifies externally that it is in processing
mode turning off the RS signal line.
When the RS signal line is not connected, interval between inputting commands should be taken
sufficiently.
2.
Transmits "Z2", in order to write the set data on the nonvolatile memory in the bar code
reader.
Be sure to write when a condition is set by inputting command from the upper equipment. When you
turn off the power without writing the setting in the memory, the set content may be deleted.
V500-R521B2/C2
54
User's Manual
Transmit command character strings.
Command
(In case of one character, m1 only)
Bar code reader
V500-R521