QUANTA STRATOS S210 Series S210-X12RS Technical Manual page 208

C T
HAPTER ITLE
screenshot of Add Event Filter Page is in seen the
screenshot below.
Figure 4-25. Add Event Filter Entry Page
3. In the Event Filter Configuration section,
PEF ID displays the ID for configured PEF entry (read-

only).
In filter configuration, check the box to enable the PEF

settings.
In Event Severity, select any one of the Event severity

from the list.
4. In the Filter Action configuration section,
W
EB
Event Filter Action is a mandatory field and checked by

default, which enable PEF Alert action (read-only).
Select any one of the Power action either Power down,

Power reset or Power cycle from the drop down list
Choose any one of the configured alert policy number

from the drop down list.
Note:
Alert Policy has to be configured - under
PEF > Alert Policy
5. In the Generator ID configuration section,
Check Generator ID Data option to fill the Generator ID

with raw data.
Generator ID 1 field is used to give raw generator ID1

data value.
Generator ID 2 field is used to give raw generator ID2

data value.
Note:
In RAW data field, to specify hexadecimal value prefix with '0x'.
In the Event Generator section, choose the event gen-

erator as Slave Address - if event was generated from
IPMB.Otherwise as System Software ID - if event was
generated from system software.
In the Slave Address/Software ID field, specify corre-

sponding I2C Slave Address or System Software ID.
4-35
G U I (GUI)
RAPHICAL SER NTERFACE
Configuration >
.
ESMS
FOR