QUANTA STRATOS S210 Series S210-X12RS Technical Manual page 205

C T
HAPTER ITLE
Table 4-23: Network Settings Page
I
TEM
LAN Interface Lists the LAN interfaces.
LAN Settings To enable or disable the LAN Settings.
This field displays the MAC Address of the
MAC Address
device. This is a read only field.
This option lists the IPv4 configuration settings.
Obtain IP Address automatically: This option

is to dynamically configure IPv4 address
using DHCP (Dynamic Host Configuration
Protocol).
IPv4 Address, Subnet Mask, and Default

Gateway: These fields are for specifying the
static IPv4 address, Subnet Mask and
IPv4 Settings
Default Gateway to be configured to the
device.
Note:
IP Address made of 4 numbers separated by

dots as in "xxx.xxx.xxx.xxx".
Each Number ranges from 0 to 255.

First Number must not be 0.

D
ESCRIPTION
4-32
W G
EB RAPHICAL
Table 4-23: Network Settings Page (Continued)
I
TEM
This option lists the following IPv6 configuration
settings.
IPv6 Settings: This option is to enable the

IPv6 settings in the device.
Obtain an IPv6 address automatically: This

option is to dynamically configure IPv6
address using DHCP (Dynamic Host
Configuration Protocol).
IPv6 Address: To specify a static IPv6

IPv6 Configuration
address to be configured to the device. Eg:
2004:2010
Subnet Prefix length: To specify the subnet

prefix length for the IPv6 settings.
Note:
Value ranges from 0 to 128.
Default Gateway: Specify v6 default gateway

for the IPv6 settings.
It lists the VLAN configuration settings.
VLAN Settings: To enable/disable the VLAN

support for selected interface.
VLAN ID: The Identification for VLAN config-

uration.
VLAN Configuration
Value ranges from 1 to 4095.

VLAN Priority: The priority for VLAN configu-

ration.
Value ranges from 1 to 7.

7 is the highest priority for VLAN.

Save To save the entries.
U I (GUI) ESMS
SER NTERFACE FOR
D
ESCRIPTION