QUANTA STRATOS S210 Series S210-X12RS Technical Manual page 197

C T
HAPTER ITLE
1. Click on Advanced Settings to open the Advanced
Active Directory Settings Page.
Figure 4-16. Advanced Active Directory Settings Page
F
2. In the Active Directory Settings Page, enter the following
details.
3. Active Directory Authentication: To enable/disable
Active Directory, check or uncheck the Enable checkbox
respectively.
Note:
If you have enabled Active Directory Authentication, enter the
required information to access the Active Directory server.
4. Specify the Domain Name for the user in the User
Domain Name field. e.g. MyDomain.com
5. Specify the time (in seconds) to wait for Active Directory
queries to complete in the Time Out field.
Note:
Default Time out value: 120 seconds.

Range from 15 to 300 allowed.

W
EB
6. Configure IP addresses in Domain Controller Server
Address1, Domain Controller Server Address2 &
Domain Controller Server Address3.
Note:
IP address of Active Directory server: At least one Domain Con-
troller Server Address must be configured.
IP Address made of 4 numbers separated by dots as in

"xxx.xxx.xxx.xxx".
Each number ranges from 0 to 255.

First number must not be 0.

Domain Controller Server Addresses will supports IPv4 Address
format and IPv6 Address format.
7. Click Save to save the entered settings and return to
Active Directory Settings Page.
8. Click Cancel to cancel the entry and return to Active
Directory Settings Page.
To add a Role Group
9. In the Active Directory Settings Page, select a blank row
and click Add Role Group to open the Add Role group
Page as shown in the screenshot below.
Figure 4-17. Add Role group Page
4-24
G U I (GUI)
RAPHICAL SER NTERFACE
ESMS
FOR