Editing By Means Of External Devices; Editing The P2 Card Data (Usb Device Mode/1394 Device Mode); Editing In The Usb Device Mode - Panasonic AG-HPG10P Operating Instructions Manual

Editing by means of external devices

Editing the P2 card data (USB DEVICE mode/1394 DEVICE mode)

You can connect a personal computer to the unit using a USB cable (for a Windows machine) or a 1394
cable (for a Macintosh machine), and operate the image data on the unit's P2 card from the computer.
Personal
computer
1394 cable (optional accessory)
For a Macintosh computer

Editing in the USB DEVICE mode

The following conditions must be met when using a USB connection.
• The PC with the hard drive must run Windows 2000 or Windows XP.
• When making a USB connection for the first time, install the P2 software from the CD-ROM provided with
the unit in the PC.
• This unit supports only USB 2.0. Use a USB 2.0-compatible PC.
• Only one PC must be connected.
• Operation will not be possible if a hub or other device is connected between the unit and PC. A USB
cable more than 3 meters long must not be used. Otherwise, malfunctioning may occur.
• No guarantees are made for the operations performed by the Macintosh operating system.
1
Hold down [POWER] for at least 2 seconds
to turn the power on.
The thumbnail screen now appears.
2
Press [THUMBNAIL/MODE] to display the
thumbnail display off screen.
3
Press [MENU/MODE CHK].
4
Using , and
FUNCTIONS" – "PC MODE", and press
5
Using and
press .
6
Press [MENU/MODE CHK] twice to display
the thumbnail display off screen.
64
USB cable
(optional accessory)
For a personal computer
running Windows
, select "OTHER
, select "USB DEVICE", and
USB 2.0 connector
(Type B)
IEEE1394 input/output
connector
7
Hold down [THUMBNAIL/MODE] for at least
2 seconds.
After "USB DEVICE" is displayed, "USB
DEVICE CONNECT" is displayed once the file
access enable status is established.
• The mode cannot be changed or menus
cannot be displayed while the USB DEVICE
mode is established.
• Do not remove the P2 card while the USB
connection is established.
.
8
Edit the data on the P2 card using the
personal computer.
9
After the data has been edited, disconnect
the USB cable.
The display on the LCD monitor changes from
"USB DEVICE CONNECT" to "USB DEVICE
DISCONNECT."
• When disconnecting the cable, perform the
"safe removal of hardware" procedure at the
personal computer.
This unit
AG -H PG
10