Copying Clips - Panasonic AG-HPG10P Operating Instructions Manual

Copying clips

Clips can be copied onto the P2 cards in either of the P2 card slots.
• While clips are being copied, do not turn off the power or eject the card. Otherwise, defective clips will be
produced. If defective clips are produced, delete them, and copy the original clips again.
• Copy incomplete clips after having connected them.
1
Display the thumbnail display screen.
2
Select the clip to be copied.
3
Press [MENU/MODE CHK].
4
Using , and , select "OPERATION"
– "COPY" – "SLOT n" (where "n" is the
number of the P2 card slot into which the
copy destination P2 card was inserted), and
press .
5
Select "YES", and press
Clip copying now starts.
• To stop the copying process at any time, press
to cancel the copying. The partially copied clip at
the copy destination will be deleted.
• If there is a clip with the same GLOBAL CLIP ID-
-one which, for instance, was previously copied
to the copy destination--"OVER WRITE" will
appear. To overwrite the existing clip, select YES
or to cancel the overwriting, select NO, and press
. ("OVER WRITE" also appears when copying
onto the P2 card a different clip which has been
recorded on a multiple number of cards.)
6
Clips cannot be copied when any of the following
error messages are displayed.
• "LACK OF REC CAPACITY!"
• "UNKNOWN CONTENTS FORMAT!"
• "NO COPY TO SAME CARD!"
.
• "TOO MANY CLIPS!"
• Clips displayed by the
• It may not be possible to copy clips for which the
When the completion message has
appeared, press "OK" ( ).
Clips will not be copied because there is
insufficient memory at the copy destination.
Clips will not be copied because the selected
clips include defective clips.
Clips will not be copied because an attempt is
being made to copy clips to the same card.
Clips will not be copied because too many clips
have been selected.
X
cannot be copied.
unknown clip indicator is displayed.
?
defective clip indicator
37