Recording - Panasonic AG-HPG10P Operating Instructions Manual

CMPNT/SDI SEL : This is used to set the format of the D connector output and HD/SD-SDI output signals.
(When SYSTEM AUTO
FREQ is set to 59.94
Hz)
1080i
480i
(When SYSTEM AUTO
FREQ is set to 50 Hz)
1080i
576i
SDI OUT ON
OFF
SDI METADATA ON
OFF
SDI EDH ON
OFF
SETUP This is used to adjust the setup level of the video output signals during playback in the
480i format.
• This item is not displayed on the menu when SYSTEM FREQ is set to 50 Hz.
0%
7.5%A
The setup level for component output (D connector), SDI output and 1394 input recording
is set to 0 %.
The HD/SD-SDI output signals comply with the following standards.
HD : SMPTE 292M, 296M, 299M
SD : SMPTE259M-C/272M-A, ITU-R BT. 656-4
The signals corresponding to the setting for SYS FORMAT item (Page 76) on the
RECORDING SETUP screen are output.
720P signals are cross-converted to 1080i signals, and output.
480i format signals are output; 720P/1080i signals are down-converted to 480i
and output.
The signals corresponding to the setting for SYS FORMAT item (Page 76) on the
RECORDING SETUP screen are output.
720P signals are cross-converted to 1080i signals, and output.
576i format signals are output; 720P/1080i signals are down-converted to 576i
and output.
SDI signals are output.
SDI signals are not output.
The meta-data is superimposed onto the HD-SDI signals.
The meta-data is not superimposed onto the HD-SDI signals.
EDH is superimposed onto the SD-SDI signals.
EDH is not superimposed onto the SD-SDI signals.
The setup level of the video output signals is set to 0 %.
The setup level of the video output signals is set to 7.5 %.
The underlined settings are the factory mode settings.
49