Saving User Files On Sd Memory Cards - Panasonic AG-HPG10P Operating Instructions Manual

Saving USER files on SD memory cards

Up to four sets of settings can be saved as four
files on the SD memory card, and they can be
loaded from the card.
1
Press [THUMBNAIL/MODE] to display the
thumbnail display off screen.
2
Press [MENU/MODE CHK].
3
Select "USER FILE" on the setting menu
"CARD FUNCTIONS" screen, select "YES",
and press .
• Basic operations on the setting menus (Page
74)
CARD FUNCTIONS
- - - -
USER FILE
SD CARD FORMAT - - - -
4
Select "FILE SELECT", and press
5
Using or , select the file number (1 to 4),
and press .
USER FILE (SD CARD)
FILE SELECT 1
READ - - - -
- - - -
WRITE
FILE 1 NO FILE
FILE 2 NO FILE
FILE 3 NO FILE
FILE 4 NO FILE
TITLE RELOAD
- - - -
6
Using and , select "WRITE", and press
.
USER FILE (SD CARD)
FILE SELECT 1
READ - - - -
WRITE YES
FILE 1 NO FILE
FILE 2 NO FILE
FILE 3 NO FILE
FILE 4 NO FILE
TITLE RELOAD - - - -
7
Display "YES" using
• In the figure below, "TITLE1" is the filename.
• After the data has been saved, "WRITE OK"
is displayed.
• The USER file which was written changes to
a white display.
USER FILE (SD CARD)
WRITE FILE 1
YES - - - - PUSH STILL
NO
TITLE EDIT
T I T L E 1
.
and , and press .
8
Press [MENU/MODE CHK] four times to
release the menu mode.
To give titles to files
1) Perform steps 1 to 6.
2) Select the characters using
move to the next character using
• The number of characters which can be input
is 8.
• Any of the following characters can be input.
(Space), A to Z, 0 to 9, : ; < = > ? @ [ \ ] ^ _
-. /
• All the characters can be deleted using the
unit's [RESET/TC SET] button.
3) After all the characters have been input, press
at the left end of the characters (or
right end), display "YES" using
• After the data has been saved, "WRITE OK"
is displayed.
To load a file
1) Perform steps 1 to 5.
2) Move to "READ" using
and press .
• The files are loaded.
3) If "TURN POWER OFF" appears after loading,
turn off the power, and then turn it back on. The
loaded files are now set.
To reload the files from the SD memory card:
1) Perform steps 1 to 3.
2) Using and , move to "TITLE RELOAD",
display "YES", and press
• The files are now re-loaded.
• If "WRITE NG FORMAT ERROR" is displayed,
format the SD memory card. (Page 28)
• If "WRITE NG WRITE PROTECT" is displayed,
release the SD memory card protection.
• If "WRITE NG CANNOT ACCESS" is displayed,
complete the other operations (such as
playback), and then proceed to operate.
• If "WRITE NG ERROR" is displayed, the SD
memory card may be defective. Replace the
card.
and , and
.
at the
, and press .
and , display "YES",
.
29