P2 Card Recording Durations; Other; Using The User Buttons; Charging The Internal Battery - Panasonic AG-HPG10P Operating Instructions Manual

P2 card recording durations

Model number Capacity
AJ-P2C004HG
AJ-P2C008HG
AJ-P2C016RG
• AJ-P2C002SG (2 GB) cards cannot be used.
• The memory needed for management and other purposes is included in the memory figure displayed, so
the amount of memory you can use for recording is less than what is displayed.
• Concerning dividing the clips recorded on P2 cards
If, when a P2 card with a memory capacity of 8 GB or more is used in this unit, the continuous recording
time for a single session exceeds the time shown in the table below, the recording will automatically
continue as another clip. Furthermore, when performing thumbnail operations (such as display, delete,
repair or copy) for clips using the P2 device, these operations can be performed with all the clips treated
as a single clip. The clips may be displayed as separate clips by non-linear editing software and PCs.
Recording format
DVCPRO HD ∗
1
DVCPRO50
DVCPRO/DV
• When any other kind of card is used, you may need to update the driver installed in the unit. (Page 92)

Other

Using the USER buttons

One of ten different functions can be allocated to
each of USER1, 2 and 3 buttons.
The following features are allocated to the buttons
at the time of shipping.
USER1: SYS FORMAT
USER2: SHOT MARK
USER3: TEXT MEMO
For details, refer to the USER1-3 items (Page 78)
on the setting menu "SW MODE" screen.
• The function allocated to [USER] will be
displayed while [MENU/MODE CHK] on the
thumbnail display off screen is held down for at
least 2 seconds.
• Depending on the mode, allocated functions may
not be operable.
DVCPRO/DV
Audio 2CH
4 GB Approx. 16 minutes
8 GB Approx. 32 minutes
16 GB Approx. 64 minutes
Recording time
Approx. 5 minutes
Approx. 10 minutes
Approx. 20 minutes
DVCPRO50
Audio 4CH
Approx. 8 minutes
Approx. 16 minutes
Approx. 32 minutes
∗1 Signals in the 720P/30PN, 720P/24PN and
720P/25PN DVCPRO HD formats cannot be recorded
using this unit.

Charging the internal battery

The date (year/month/day) and time are stored in
the memory by the internal battery. When the
display has appeared on the LCD monitor screen,
it means that the internal battery charge is low.
Follow the steps below to charge the battery. After
the battery has been fully charged, set the date
and time.
1
Connect the AC adapter to the unit.
Keep the unit's power turned off.
2
Maintain this condition for about 4 hours.
The internal battery will now be charged.
After charging, check the TC and menu.
If appears even after the internal battery has
been charged, the battery must be replaced. Ask
your dealer for another battery.
DVCPRO HD ∗
1
Approx. 4 minutes
Approx. 8 minutes
Approx. 16 minutes
27