Copying Data From P2 Cards To The Hard Drive; Hard Drive Status Displays - Panasonic AG-HPG10P Operating Instructions Manual

Copying data from P2 cards to the
hard drive
• Use a hard drive with enough memory to
accommodate the data to be copied.
• Proceed with copying after checking that the unit
has a sufficient remaining battery charge.
1
After inserting the copy source P2 card into
the unit's P2 card slot, select "COPY TO
HDD" using and
COPY TO HDD
FORMAT (HDD)
PROPERTY
SETUP
• The data is copied onto the hard drive one
card at a time.
2
Using and , select the card slot, and
press .
Then select "YES" using
Copying now begins.
• To stop copying at any time, press
Select "YES" on the confirmation screen, and
press .
• The data of up to 15 cards can be stored on
the hard drive.
COPY TO HDD
SLOT1
FORMAT (HDD)
SLOT2
PROPERTY
EXIT
SETUP
To verify (inspect the two sets of data) after
copying data onto a hard drive
Switch to the 1394 HOST mode, and select
"SETUP" – "VERIFY" – "ON" using
and press .
• The copying of the P2 card data will also be
terminated if the process is aborted during
verification of the two sets of data.
, and press .
, and press .
.
SURE?
YES
NO
, and ,

Hard drive status displays

You can display the status of the hard drive which
is connected to the unit.
1
Using and , select "PROPERTY", and
press .
1
2
3
4
5
1. VENDER Name of vender
2. MODEL Hard drive model name
3. SIZE Total memory size of hard
drive
4. USED Amount of hard drive memory
used (unit: GB) and area of
P2 card used (unit: cards)
5. REMAIN Remaining hard drive
memory (unit: GB)
2
Using and , select the partition, and
press .
Detailed information of the partition is now
displayed.
3
Press [MENU/MODE CHK] to complete the
process.
• You cannot copy data from a hard drive onto a
P2 card.
• Supply power from a source other than the 1394
bus. (Power is not supplied from the unit itself.)
• No guarantees for operation are given if the
1394 HOST mode is established first without
connecting the hard drive (which supports 1394.
a SBP2) and then the hard drive is connected.
In a case like this, turn off the power, turn it back
on, and release the 1394 HOST mode.
• In the 1394 HOST mode, the clips in the partition
will not be displayed as thumbnails.
• In the 1394 HOST mode, no signals can be
output to an external monitor.
63