Emmc Board - HP 15 Maintenance And Service Manual

Reverse this procedure to install the optical drive connector cable.

eMMC board

Description
eMMC board, 32 GB
eMMC cable
Before removing the eMMC board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Service door (see
c. WLAN module (see
d. Memory module (see
e. Keyboard (see
f. Top cover (see
Remove the eMMC board:
1. Disconnect the eMMC board cable (1) from the system board.
2. Remove the two Phillips M2.5×4.0 (2) that secure the board to the base enclosure.
Battery on page 27), and then remove the following components:
Optical drive on page
Service door on page
WLAN module on page
Memory module on page
Keyboard on page 37).
Top cover on page 40).
32).
28).
30).
29).
Component replacement procedures
Spare part number
776777-001
776775-001
53