HP 15 Maintenance And Service Manual page 67

2. Remove the two Phillips M2.5×6.5 and M2.0×5.0 screws (1). Remove the bracket (2) that secures
the power connector bracket to the base enclosure.
3. Remove the four Phillips M2.5×5.0 screws (1) that secure the system board to the base enclosure.
4. Lift the right side of the system board (2) until it rests at an angle.
5. Carefully remove from the power connector (3). Remove the system board by sliding it up and to the
right at an angle and pull the system board (4) carefully to the right.
Component replacement procedures 57