Touchpad Button Board - HP 245 G6 Maintenance And Service Manual

TouchPad button board

Description
TouchPad button board
TouchPad button board cable
TouchPad cable
Before removing the TouchPad button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the TouchPad button board:
1. Disconnect the cable from the TouchPad button board (1).
2. Remove the two Phillips PM2.0×3.0 screws (2) that secure the TouchPad button board to the computer.
3. Lift the bottom of the board upward, and then remove it from the computer (3).
Reverse this procedure to install the TouchPad button board.
Battery on page 28).
Optical drive on page
Bottom cover on page
29), if installed.
35).
Component replacement procedures
Spare part number
925365-001
925344-001
925346-001
45