HP 15 Maintenance And Service Manual page 78

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly spare
part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Service door (see
c. WLAN module (see
d. Memory module (see
e. Keyboard (see
f. Top cover (see
g. Hard drive (see
h. System board (see
Remove the display assembly:
1. Remove the three Phillips M2.5×5.0 screws (1) and Phillips M2.5×2.5 broadhead screw (2) that secures
the display assembly to the base enclosure.
68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 27), and then remove the following components:
Optical drive on page 32).
Service door on page 28).
WLAN module on page
Memory module on page
Keyboard on page 37).
Top cover on page 40).
Hard drive on page 44).
System board on page
30).
29).
55).